Specialized Electronics Services Repairs All Laser Parts.
CALL US TODAY TOLL FREE: 1-800-681-7374
GSI 229.232.00 – TS232 Interconnect Board
TS232 Interconnect Board A cable interconnect board is used to interconnect the forcer assembly to the 8085 control bus in the card cage backplane. This board is identified as the TS232 Interconnect Board in Figure 3-4, on page 3-5 (note connections). The TS232 is not mounted in the card cage. Instead, it is mounted to the upper horizontal bulkhead in the M310 cabinet, providing a pass-through between the upper and lower sections of the M310 cabinet.
The TS232 is accessible from above when the beam box is raised or from the left (card cage) side of the cabinet through an inspection panel located above and to the rear of the card cage. Figure 3- 30 shows the TS232 board as seen through this access panel. The underside of the TS232 card is shown in Figure 3-31 as seen from below. Note that the C3/ C6 connector combination and the BNC connector (C9) are not used in standard systems.
In order to minimize the time required to perform maintenance or repairs on your system, it is advisable to maintain a local supply of spare parts.
The quantity and nature of these spare parts is determined by the Periodic Maintenance requirements of the system, and by the number of systems that are installed at your location.
It may also be important to consider the difficulty of shipping components to your location. Spare parts can be ordered either through Specialized Electronic Services. Toll free phone numbers are available. Call Now!
You can also email inquiries regarding the availability of spare parts can be addressed to:
Note: When ordering parts such as galvanometers, lasers or expensive optics, consult SES before you consult other vendors. SES has years of experience and will give you the best pricing and service in the industry.
SES – CALL NOW TOLL FREE: 1-800-681-7374